If you have been reading about AEDG tetrapeptide and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-12-18. Numbers and descriptions here follow the published literature rather than marketing material.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
（TG:@pojiaai）Epitalon is a synthetic linear tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. It emerged from work on epithalamin, a peptide fraction prepared from bovine pineal tissue, and was designed as a short, chemically defined analogue of that extract. Early publications came mainly from Russian laboratories studying pineal peptides and aging-related endpoints. The compound appears in the literature under several spellings, including epithalon and epithalone, which complicates systematic searching. Its small size makes solid-phase assembly and routine analytical characterization straightforward.
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
The published literature is dominated by a small number of research groups, much of it in Russian-language journals, and independent replication outside those groups is limited. Studies are typically small, use cultured cells or rodent models, and report endpoints that differ between papers, which makes comparison difficult. Large randomised human trials have not appeared in the indexed literature. Questions about absorption, distribution and clearance are therefore still treated as open in reviews that mention the compound.
Epitalon is a synthetic tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. Its design traces to epithalamin, a peptide fraction prepared from bovine pineal gland extracts that researchers in Saint Petersburg began investigating in the 1970s. The compound has a molecular formula of C14H22N4O9 and a nominal molecular mass near 390 daltons. It holds no approved drug status in the United States or the European Union, and material sold under this name is generally offered as a research chemical rather than a finished pharmaceutical product.
Proposed mechanisms centre on cell-culture observations rather than a defined receptor interaction. Several reports describe increased expression of the telomerase catalytic subunit after exposure of cultured human cells, and the authors attributed the effect to short peptide fragments entering the nucleus and influencing gene transcription. No receptor for the tetrapeptide has been identified, and the free peptide is expected to be degraded rapidly by plasma peptidases. Whether any measurable fraction reaches intact tissues after administration remains an unresolved question rather than an established finding.
In hemodialysis, the patient's blood is pumped through the blood compartment of a dialyzer, exposing it to a partially permeable membrane. The dialyzer is composed of thousands of tiny hollow synthetic fibers. The fiber wall acts as the semipermeable membrane. Blood flows through the fibers, dialysis solution flows around the outside of the fibers, and water and wastes move between these two solutions. The cleansed blood is then returned via the circuit back to the body. Ultrafiltration occurs by increasing the hydrostatic pressure across the dialyzer membrane. This usually is done by applying a negative pressure to the dialysate compartment of the dialyzer. This pressure gradient causes water and dissolved solutes to move from blood to dialysate and allows the removal of several litres of excess fluid during a typical 4-hour treatment. In the United States, hemodialysis treatments are typically given in a dialysis center three times per week (due in the United States to Medicare reimbursement rules); however, as of 2005 over 2,500 people in the United States are dialyzing at home more frequently for various treatment lengths. Studies have demonstrated the clinical benefits of dialyzing 5 to 7 times a week, for 6 to 8 hours. This type of hemodialysis is usually called nocturnal daily hemodialysis and a study has shown it provides a significant improvement in both small and large molecular weight clearance and decreases the need for phosphate binders.
== Broadcast == Matlock premiered with a sneak peek on September 22, 2024, before its timeslot premiere on October 17 on CBS. In Canada, the series airs on Global and is available to stream on StackTV. The second season premiered on October 12, 2025. In Australia, the show premiered on Channel Ten on the November 11, 2024 and has continued to air its second season through January 2026 and also airs on Paramount+. In Croatia, the show premiered on national HRT 1 starting with the first season on the 15th. June 2026.
== History == In the 18th century, William Withering discovered that arsenic trioxide, when used in small doses, exhibited therapeutic effects. During the same period, Thomas Fowler prepared a 1% solution of arsenic and potassium carbonate, which was used to treat skin diseases (primarily psoriasis) until the 20th century. An arsenic-based drug, arsphenamine, was also developed for the treatment of syphilis, synthesized by Paul Ehrlich, though it was eventually replaced by penicillin. Arsenic compounds were widely used to treat various diseases in the 19th and early 20th centuries. The first reports of the anticancer activity of arsenic trioxide date back to 1878, when a report from Boston City Hospital described Fowler's solution lowering leukocyte levels in the blood of two healthy individuals and one patient. Arsenic trioxide continued to be used in the treatment of leukemia until the introduction of radiotherapy. It made a resurgence in the 1930s when the first studies confirmed the high efficacy of arsenic trioxide in treating chronic myelogenous leukemia. In the late 1960s, physicians working at the Harbin Medical Academy in China were sent to a center focusing on traditional Chinese medicine, where they used a melanoma ointment, with arsenic as its main ingredient. At that time, the arsenal of anticancer drugs was limited, prompting doctors to experiment with arsenic. Early trials used oral administration, but it showed strong toxic effects. In March 1971, the first trials of intravenous arsenic began, which showed significantly lower toxicity.
Sources: en.wikipedia.org
Nucleases are enzymes that cut DNA strands by catalyzing the hydrolysis of the phosphodiester bonds. Nucleases that hydrolyse nucleotides from the ends of DNA strands are called exonucleases, while endonucleases cut within strands. The most frequently used nucleases in molecular biology are the restriction endonucleases, which cut DNA at specific sequences. For instance, the EcoRV enzyme shown to the left recognizes the 6-base sequence 5′-GATATC-3′ and makes a cut at the horizontal line. In nature, these enzymes protect bacteria against phage infection by digesting the phage DNA when it enters the bacterial cell, acting as part of the restriction modification system. In technology, these sequence-specific nucleases are used in molecular cloning and DNA fingerprinting. Enzymes called DNA ligases can rejoin cut or broken DNA strands. Ligases are particularly important in lagging strand DNA replication, as they join the short segments of DNA produced at the replication fork into a complete copy of the DNA template. They are also used in DNA repair and genetic recombination.
=== Industrial === Industrial biotechnology (known mainly in Europe as white biotechnology) is the application of biotechnology for industrial purposes, including industrial fermentation. It includes the practice of using cells such as microorganisms, or components of cells like enzymes, to generate industrially useful products in sectors such as chemicals, food and feed, detergents, paper and pulp, textiles and biofuels. In the current decades, significant progress has been done in creating genetically modified organisms (GMOs) that enhance the diversity of applications and economical viability of industrial biotechnology. By using renewable raw materials to produce a variety of chemicals and fuels, industrial biotechnology is actively advancing towards lowering greenhouse gas emissions and moving away from a petrochemical-based economy. Synthetic biology is considered one of the essential cornerstones in industrial biotechnology due to its financial and sustainable contribution to the manufacturing sector. Jointly biotechnology and synthetic biology play a crucial role in generating cost-effective products with nature-friendly features by using bio-based production instead of fossil-based. Synthetic biology can be used to engineer model microorganisms, such as Escherichia coli, by genome editing tools to enhance their ability to produce bio-based products, such as bioproduction of medicines and biofuels. For instance, E.
== Profibrillin cleavage and asprosin secretion == The asprosin mechanism begins with the cleavage of profibrillin-1. While the specific cellular location of profibrillin-1 cleavage is largely unknown, it is speculated to occur between the trans-Golgi network and the cell surface, or upon fibrillin-1 secretion. Furin cleaves asprosin at the R-C-K/R-R motif in the C-terminal domain. This cleavage event is important because it is required for the incorporation of fibrillin-1 into the extracellular matrix. Since furin is expressed in a plethora of cell lines and tissues, the presence or lack of this enzyme does not narrow down the possible locations of asprosin secretion. Evidence suggests that asprosin is secreted from white adipose tissue, which accounts for 5–50% of human body weight and is already known to secrete adipokines such as leptin and adiponectin. While FBN1 is expressed in many tissues, its highest expression in both humans and mice is in white adipose. However, since FBN1 (and thus, asprosin) is widely expressed in many human tissues, it is likely that white adipose is not the only source of plasma asprosin. There has been evidence connecting asprosin secretion from wild-type human dermal fibroblasts suggesting that it may be secreted from skin. It was also discovered that MIN6 pancreatic β-cells and human primary islets containing β-cells secrete asprosin and that secretion is induced by palmitate in a dose-dependent manner. Asprosin has also been detected in saliva samples.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
It is a four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine. The chain is unmodified and contains only standard proteinogenic residues, which makes it straightforward to produce by solid-phase synthesis and to characterise by standard peptide methods.