Everything below concerns electrospray ionisation. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2025-11-12. Numbers and descriptions here follow the published literature rather than marketing material.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Electrospray or MALDI mass spectrometry | Observed mass compared with theoretical 390.35 Da |
| Purity specification | 95 percent or greater by RP-HPLC | Common convention for research-grade peptide |
| Counter-ion | Acetate or trifluoroacetate | Affects net peptide content of a weighed sample |
| Solution storage | −80 °C as single-use aliquots | Repeated freeze–thaw cycles accelerate loss |
| Main degradation route | Aspartimide formation at Asp-Gly | Produces isoaspartate and related species |
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Peptides of this size are generally stable as dry solids but degrade in solution over time. The principal routes are hydrolysis of the peptide backbone and oxidation, with hydrolysis favoured by elevated temperature and extreme pH. Aqueous solutions held at room temperature can show measurable loss of purity within days, while frozen aliquots are considerably more durable. Because the sequence contains neither cysteine nor methionine, oxidation is less of a concern than for many other peptides, but pH control during handling still matters.
Typical storage for the lyophilized powder is −20 °C or lower, in a sealed container protected from light and moisture. Hygroscopic material should be allowed to equilibrate to room temperature before the vial is opened, which limits condensation on the contents. Working solutions are commonly divided into single-use aliquots and frozen to avoid repeated freeze-thaw cycles. Dilute solutions are more prone to adsorption onto plastic surfaces and to loss during filtration, so procedures that minimize transfers and use low-binding labware are preferable.
=== Obesity === In 1984, researchers at the University of Rochester Medical Center reported that they had performed a double-blind, controlled clinical trial comparing phentermine alone, fenfluramine alone, a combination of phentermine and fenfluramine, and placebo, for weight loss in humans. Weight loss in those receiving the fen-phen combination was significantly greater (8.4±1.1 kg) than in those receiving placebo (4.4±0.9 kg) and equivalent to that of those receiving fenfluramine (7.5±1.2 kg) or phentermine alone (10.0±1.2 kg). This amounts to an additional weight loss of 4±2 kg over the course of 24 weeks. Adverse effects were less frequent with the combination regimen than with the other active (non-placebo) treatments. The authors felt that combining fenfluramine and phentermine capitalized on their pharmacodynamic differences, resulting in equivalent weight loss, fewer adverse effects, and better appetite control.
Usually, organometallic compounds are considered to contain the M-C-H group. The metal (M) in these species can either be a main group element or a transition metal. Operationally, the definition of an organometallic compound is more relaxed to include also highly lipophilic complexes such as metal carbonyls and even metal alkoxides. Organometallic compounds are mainly considered a special category because organic ligands are often sensitive to hydrolysis or oxidation, necessitating that organometallic chemistry employs more specialized preparative methods than was traditional in Werner-type complexes. Synthetic methodology, especially the ability to manipulate complexes in solvents of low coordinating power, enabled the exploration of very weakly coordinating ligands such as hydrocarbons, H2, and N2. Because the ligands are petrochemicals in some sense, the area of organometallic chemistry has greatly benefited from its relevance to industry.
The news website Tortoise Media reports that the Conservatives have received a further £5m in donations from Frank Hester that are yet to be declared. 16 March Vaughan Gething is elected to lead Welsh Labour, and will become First Minister of Wales. He will be Wales's first black leader, and the first black person to lead a country in Europe. Sainsbury's apologises to its online customers after a technical error meant that orders could not be fulfilled. 18 March – At Manchester Crown Court, Jacob Graham is sentenced to 13 years in prison together with a further five year extended period on licence for creating a "freedom encyclopaedia" containing details on how to build weapons for the purposes of terrorism. 19 March At Southend Crown Court, 39-year-old Nicholas Hawkes, the first person in England and Wales to be convicted of cyberflashing, is sentenced to 66 weeks in prison. This new offence follows passage of the Online Safety Act, which came into effect on 31 January. HMRC announces that its self-assessment helpline will be closed for six months of the year, with the line scheduled to close from 8 April to 30 September. Customers seeking help during that period will be forced to use an online chatbot. The British Board of Film Classification updates its guidelines, meaning films containing scenes of sex or nudity are more likely to receive a 15 rather than a 12A rating going forward. 20 March Inflation falls from 4% to 3.4%, its lowest rate since September 2021.
Sources: en.wikipedia.org
== Metabolism == In the main pathway to quinolinic acid, the next step is an oxidation reaction catalysed by kynurenine 3-hydroxylase, which uses oxygen and nicotinamide adenine dinucleotide phosphate (NADPH) to place a phenolic group next to the aromatic amine.
== Kaposi's sarcoma (176–176) == 176 Kaposi's sarcoma 176.0 Kaposi's sarcoma skin 176.1 Kaposi's sarcoma soft tissue 176.2 Kaposi's sarcoma palate 176.3 Kaposi's sarcoma gastrointestinal sites 176.4 Kaposi's sarcoma 176.5 Kaposi's sarcoma lymph nodes 176.8 Kaposi's sarcoma other specified sites 176.9 Kaposi's sarcoma unspecified site
=== Cardiac biomarkers === There are many different biomarkers used to determine the presence of cardiac muscle damage. Troponins, measured through a blood test, are considered to be the best, and are preferred because they have greater sensitivity and specificity for measuring injury to the heart muscle than other tests. A rise in troponin occurs within 2–3 hours of injury to the heart muscle, and peaks within 1–2 days. The level of the troponin, as well as a change over time, are useful in measuring and diagnosing or excluding myocardial infarctions, and the diagnostic accuracy of troponin testing is improving over time. One high-sensitivity cardiac troponin can rule out a heart attack as long as the ECG is normal. Other tests, such as CK-MB or myoglobin, are discouraged. CK-MB is not as specific as troponins for acute myocardial injury, and may be elevated with past cardiac surgery, inflammation or electrical cardioversion; it rises within 4–8 hours and returns to normal within 2–3 days. Copeptin may be useful to rule out MI rapidly when used along with troponin.
John E. Macor is an American medicinal chemist known for his contributions to drug discovery in neuroscience and other therapeutic areas. He is a co-inventor of four drugs approved by the U.S. Food and Drug Administration (FDA): the migraine treatments eletriptan (Relpax), rimegepant (Nurtec ODT), and zavegepant (Zavzpret), and sparsentan (Filspari), a treatment for IgA nephropathy. In 2014, he was inducted into the Hall of Fame of the American Chemical Society’s Division of Medicinal Chemistry. Macor currently works at Babylon Biosciences, a San Francisco-based startup focused on treatments for Alzheimer's disease.
Sources: en.wikipedia.org
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.
Yes. Trifluoroacetate and acetate ions remain associated with the peptide after purification, so a weighed quantity of powder contains less peptide than the nominal mass suggests. Certificates that report net peptide content rather than raw weight are more directly comparable between suppliers.
Dilute aqueous solutions are less stable than the dry powder and are usually aliquoted and frozen to avoid repeated freeze–thaw cycles. Lyophilised material is best stored desiccated at −20 °C, protected from light. Working solutions are typically prepared fresh from a frozen aliquot.
It is a four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine. The chain is unmodified and contains only standard proteinogenic residues, which makes it straightforward to produce by solid-phase synthesis and to characterise by standard peptide methods.